7000 108-311 B
R4 IAIS System: Short Instruction guide for Inland AIS Operation
General Operation
Turning On and Off
To turn the R4 display unit on, press the
POWER
key. To turn the display off,
hold the
POWER
key down for three seconds.
Acknowledge active alarms
Use the
ENTER
key to acknowledge alarm indications on the display.
Changing parameters
Use the
ARROW KEYPAD
to step between parameters in a view. To change a
parameter, press the
ENTER
key. Existing values can be erased using function
key
Backspace
. When the parameter has been set to its desired value press the
ENTER
key again. When all parameters in the view have desired values, press
function key
Apply and Exit
. A password may now be required. If so, press
function key
Capslock
, enter ‘user’ and finally press the
ENTER
key.
Inland AIS Mode
Operation as an Inland AIS transponder system is indicated by an
IAIS
icon in the status bar at the top of the display. To enable Inland AIS Mode,
go to the
System Mode
view by pressing the
MODE
key followed by
function key
CONFIG,
the
PAGE
key
and then function key
System Mode
.
The
Inland AIS Mode Enabled
parameter shall be set to ‘Yes’.
