Motor
Motor Support
(H0143-S)
Button Head Cap Screw M4x8mm
.....x2
Set Screw M5x20mm
(HC158-S)
Set Screw M4x4mm
.....x2
Finishing Washer
M3
(H0007-S)
.....x2
.....x2
.....x2
.....x4
Set Screw M5x20mm
Socket Head Cap
Screw M3x10mm
(HC056-S)
Socket Head Cap
Screw M3x10mm
(HC056-S)
Finishing Washer
M3
(H0007-S)
34mm
6mm
6mm
.....x2
7mm
0/0.2mm
Set Screw M4x4mm
(HC152-S)
Button Head Cap Screw
M4x8mm
(HC098-S)
20T Pulley
(H0015-20-S)
Lock motor pulley after
locking H0142
(see page 28 for optional
pulley selection)
Socket Head Cap Screw M3x8mm
Spring
HC314
(HC315-S)
Washer
5.3x 15x1mm
(HC188-S)
Metric Hex Nylon Nut
M5 Low
(HC218-S)
Spring
HC310
(HC315-S)
Washer 5.3x 15x1mm
Socket Head Cap Screw M3x10mm
Finishing Washer M3
Note:
To maximize space for the batteries,
it is advisable to shorten the motor
shaft.
Follow the dimensions given in this
drawing. For the cut, you can use an
electric tool like a “Dremel” with a
cut-off disc.
Additionally, ensure the motor shaft
has an appropriate 'flat' for one of
the set screws.
Socket Head Cap
Screw M3x8mm
(HC050-S)
Bearing Support (H0142-S)
Lock H0142 after have locked
the motor.Motor shaft is requires
to optimize the centering.
H0142 can not be used with motor
shaft 8mm.
Copyright@2012 - SAB Heli Division - All rights reserved
Page 13
Chapter 5, Transmission Assembly
