Approx 628mm
G
H
I
BAG17
Head Cap Screw M2x8mm
(HC008-S)
Carbon Rod Support
(H1315-S)
Before installing the plastic link on the threaded rod, be sure that you have waited at least 12 hours for the glue to fully cure.
Plastic Ball Link
(H0066-S)
Plastic Ball Link
(H0066-S)
NOTE:
Before installing the plastic link onto the ball,
be sure the tail push rod moves smoothly.
You can open up H1315-S if you need to.
NOTE:
The carbon rod is slightly bent, generating a little preload against
the carbon rod support. Check the movement of the rod.
If it is a little tight you can enlarge the hole of the carbon rod
support using a 5mm shaft.
Page 25
TAIL BOOM ASSEMBLY