Socket Head Cap
Screw M3x10mm
(HC056-S)
BAG21
To fit the tail belt, loosen the tail case by loosening the 4 M3 screws (
Figure 1
).
*Install the belt onto the tail front pulley, checking the direction of rotation.
*Insert and tighten the four M3 screws in the boom plate.
*Rotate the tail drive several times by hand.
*Tension the tail case by hand and slowly tighten the 2 BLACK screws in (
Figure 2
).
NOTE:
To disassemble the tail boom, you have to remove the 4 M3 screws.
DO NOT
loosen the 3 M8 plastic screw.
NOTE:
Be sure that the
servo wire does not get
in contact with the belt.
Socket Head Cap
Screw M3x10mm
(HC056-S)
Washer
3x 7x1mm
(HC181-S)
Washer
3x 7x1mm
(HC181-S)
Page 29
ASSEMBLING OF THE MODULES
