Flat Head Cap
Screw M3x5mm
(HC132-S)
Fit in this holes
BAG23, FOAM 1
FBL ASSEMBLY
Flat Head Cap
Screw M3x5mm
(HC132-S)
CF FBL Mount
[H1238]
Alu FBL Support
(H1237-S)
FBL SUPPORT
ASSEMBLY
Socket Head Cap
Screw M2.5x8mm
(HC020-S)
Socket Head Cap
Screw M2.5x8mm
(HC020-S)
Finishing
Washer M2.5
(H0255-S)
Finishing
Washer M2.5
(H0255-S)
Rubber 65 shore
(HC573-S)
RX SUPPORT ASSEMBLY
Socket Head Cap
Screw M2.5x8mm
(HC020-S)
Finishing
Washer M2.5
(H0255-S)
RX Plate
[H1106]
RX Column
[H1105]
Socket Head Cap
Screw M2.5x8mm
(HC020-S)
FBL Support
Assembled
We suggest installing the flybarless mount without the shock absorber.
This will give you the most direct feeling of the model.
You can use the small plate to support any separate RX.
RUBBER DAMPENERS
However, if you have issues with rescue feature of the FBL unit, you can use the rubber dampeners to reduce
any kind of vibrations.
The sensor used for the RESCUE function is different from the flight management sensor.
The filtration capability is different.
Our testing showed that the support system with the rubber dampeners can improve the filtering capability.
Normally the rescue function has a feature for checking the correct initialization. Verify the absence of
anomalies.
By Using rubber dampeners it is not suggested to install the RX on the plate H1237.
The bottom surface of the rear servo is a good location to install an external RX ( with double-sided tape ).
Alu FBL Support
(H1237-S)
NOTE:
Tighten the rubber dampeners with your fingers.
No need to use tools.
Note: Use Thread Locker Medium Strength
Flat Head Cap
Screw M3x5mm
(HC132-S)
Page 32
INSTALLATION FBL/RX
