FLYBARLESS CONTROL UNIT AND RX INSTALLATION
Figures 1
shows an example of installation of the flybarless control unit.
You can use short spacer H0727 (
Figure 2
).
You can use long spacer H0043 (
Figure 3
). This is typical if you want to put RX satellite under the control unit.
Slot for sensor cable
It is important to lock the plugs of the
flybarless unit with an adhesive - for
example hot glue.
Tail servo extension cable
For Flybarless systems with a separate sensor, the sensor must be installed under the main plate (
Figure 4
).
In
Figure 5
you can see the extension lead for the tail servo. It is very important to include a connector for fast
disassembly of the boom module.
The connector will prevent servo damage in case of boom separation during a crash.
Support
Flybarless
(H0077-S)
Spacer Support
Flybarless
(H0727-S)
Socket Head Cap
Screw M3x6mm
(HC044-S)
Flybarless Unit
Socket Head Cap
Screw M3x6mm
(HC044-S)
Double-sided
Tape
BAG 9
If you want to assembly RX under FBL
support. You can use H0043 [ 26mm ].
If you want to assembly RX under FBL
support. You can use H0043 [ 26mm ].
Flat Head Cap
Screw M3x8mm
(HC134-S)
[H0043]
RX
Page 20
Chapter 11, Installation Of Flybarless Unit and RX
