Servo Spacer
(H0075-S)
Carbon Rod Assembly
(HC237-S)
Socket Head Cap
Screw M2x6mm
(HC004-S)
Tail Servo Assembly
15-16mm
The distance between
the axis and the ball must
be between 15-16 mm
Uniball M2 5H6
(H0064-S)
Tail Servo
The tail servo wire lead must not be allowed to move
above this line (figure 1). To ensure this, it is necessary to
position it and then secure with hot glue in the area
indicated by the arrow. Figure 2 shows the installed servo.
Note:
Please note that the boom edges might be
rough and can eventually chafe or cut your tail servo
lead - we recommend protecting the leads with heat
shrink or even electrical tape.
Socket Head Cap
Screw M2.5x12mm
(HC026-S)
BAG 16
Page 25
Chapter 12, Tail Servo Installation
