START Testing
1� Clean the parts of the refrigerator with lukewarm water
containing a little neutral detergent and with clear water, and
wipe them dry�
Notes: Electric parts of the refrigerator can only be wiped by dry
cloth�
2� Turn on electricity� The compressor begins to
work�
3� Open the door 30 minutes later, if the
temperature in the refrigerator decreased
obviously, it shows that the refrigerator
system works well� When the refrigerator
operates for a period of time, the
temperature controller will automatically
set the temperature within limits it opens�
The display is located in the middle of the
refrigerator door� Please refer to the below
figure for the layout�
Introduction of the buttons
– Réfrigérateur: to set the refrigerator
temperature
– Congélateur: to set the freezer temperature
– Fonctions: to choose functions of fast
cooling, fast freezing, Smart Eco and
vacation
– OK: to enter or to quit the existing function
Cleaning before use
Wipe the inside of the Fridge/Freezer with a weak solution of
bicarbonate of soda� Then rinse with warm water using a damp
sponge or cloth� Wash the baskets and shelves in warm soapy
water and dry completely before replacing in the Fridge/Freezer�
The external parts of the Fridge/Freezer can be cleaned with wax
polish�
Before plugging in YOU MUST
Check that you have a socket which is compatible with the plug
supplied with the Fridge/Freezer� If not see the section called
ELECTRICAL INFORMATION
Before switching on!
DO NOT SWITCH ON UNTIL FOUR HOURS AFTER MOVING THE
FRIDGE/FREEZER�
The coolant fluid needs time to settle� If the appliance is switched
off at any time, wait 30 minutes before switching back on to
allow the coolant fluid to settle�
Before filling your Fridge/Freezer
Before storing foods in your Fridge/Freezer, turn the Fridge/
Freezer on and wait for 24 hours, to make sure it is working
properly and to allow the Fridge/Freezer to fail to the correct
temperature�
38
37
GB
GB
