3. LED Light Power Connection.
Option 1:
This side burner has been supplied with enough wire to mount the 9V battery box up to 5 ½ ft from the bottom of the side burner as
shown in Figure 1 below. The exact mounting location can vary based on the design of your enclosure. Mounting holes are
provided in the battery box mounting bracket. Be sure to route all wires away from sharp edges that could cut or damage the
insulation. Also be sure to route the wire in a manner that will not allow them to come into contact with hot surfaces. NOTE: The
9V battery box must be mounted so as to have easy access to the battery compartment for battery replacement. The battery box
must be removed from the mounting bracket to remove the battery as shown in Figure 2 below. Connect the wire harness
connector from the battery box to the mating connector on the ft LED grill conversion wire. Connect the other end of the
conversion wire to the side burner LED wire harness located at the bottom left side panel on the side burner firebox (see Figure 3).
Option 2:
If the side burner is to be installed along with a model R50SB1517 or R67SB1017 built-in grill, you may use the 120V LED
transformer provided with the grill to power the side burner LED lights as well. Using the 5 ½ ft LED grill conversion wire provided
with the side burner, connect the wire harness connector on the extension wire to the spare harness connector on the grill side of
the transformer as shown in Figure 4 below.
INSTALLATION CON’T.
10
Battery
Installation
1
2
3
Figure 3
Figure 2
Figure 4
Option 1
Option 2
Figure 1
Fasteners
not
included
