10
1. Building The Enclosure:
NOTE: If this grill is to be used as a replacement grill in an existing grill enclosure, consult your local contractor to
determine if the grill will work correctly with your existing enclosure.
Consult the table below for enclosure cut-out dimensions.
Four 1/4-20 threaded inserts are located on the bottom of the grill to be used to secure the grill to the enclosure (reference mounting
hole location). It is recommended that only 1/4-20 304 stainless steel fasteners be used to secure the grill in the enclosure.
NOTE: Area directly beneath the grill must be open. No solid surface.
Materials included:
Built-In Grill Unit
Materials not included:
Enclosure construction materials, support brackets for built-in unit, fasteners for attachment of support
bracket
.
brackets.
NOTE: ENCLOSURE MUST BE CONSTRUCTED OF NON-COMBUSTIBLE MATERIALS.
INSTALLATION
WARNING
FOR LP GAS CONVERSION:
Ÿ
Conversion to LP gas must be performed by a certified gas technician.
Ÿ
LP Conversion Kit Model A00AA5517 must be used. Specific details for enclosure construction are included
in the conversion kit instructions.
Ÿ
Additional enclosure venting construction is required.
Ÿ
A tank mounting bracket must be added to enclosure (provided with conversion kit).
Dim. C
Built-
In
Unit
Dim. B
Dim. A
GRILL MODEL
Dim. A
Dim. B
Dim. C
Dim. D
Dim. E
R50SB0417
28.25”
22.00”
9.00”
20.25”
27.00”
R67SB0317
37.00”
22.00”
9.00”
20.25”
35.63”
Dim. D
Dim. E
Mounting Hole
Location
Cut Out
Front
Cut Out
Side
Front
Enclosure
Top View
Enclosure
Front View
Bottom View
Of Grill
1/4-20 Threaded
Inserts
Built-
In
Unit
Dim. B
Dim. A
Cut Out
Front
Enclosure
Top View
