11
2. Electronic Ignition Module:
NOTE: A licensed electrician should be used to install the ignition module and make any wiring extensions or
modifications.
This grill has been supplied with enough wire to mount the ignition module in the location shown in Figure 1.
The ignition module must be mounted so as to have easy access to the battery compartment for battery replacement (see
Figure 2).
Connect wires to the small and large connections on the rear of the ignition module (see Figure 3).
INSTALLATION CON’T.
Ignition Module
& Heat Shield
Figure 1
Rotate cap counterclockwise
to open battery compartment.
Figure 2
2 Large Connectors
4 Small
Connectors
Figure 3
R67SB0317
R50SB0417
2 Large Connectors
3 Small
Connectors
Portion of Grill Shown
for Illustration Only
3 ft
