Six Drawer Base Cabinet
TOOLS REQUIRED
Phillips
Screw
Driver
10 mm Ratchet/Socket
Thoroughly Clean the Assembly Area
Remove Personal Items that Can Scratch the Cabinet Finish -
Watches, Belt, Rings, etc.
Open Cartons Carefully to Avoid Damaging Cabinet Panels
Compare Carton Contents with Parts List Count
Use the Shipping Cartons for the Assembly Surface -
Do Not Assemble on Concrete
If Using a Cordless Drill for Assembly -
Dial Drill Torque to a Low Setting
STEP 1 -
continued on next page
Tape Measure
Page 4
10 mm Open End Wrench
BEFORE YOU BEGIN:
Remove All Drawers From Cabinet - Important Note -
Sometimes the rubber keepers on the
drawer slides will make the drawers feel like they are locked. Place a flat head screwdriver between the
side of the drawer and the side panel and
Gently Pry
. Drawer will pop open.
Label and number each drawer (1 through 6) with masking tape. Open Top Drawer to fully extended
position. Push down on Right Drawer Slide release levers and push slide bodies towards cabinet. Re-
peat the procedure on the Left Drawer Slides. If Drawer does not release from slide, reverse the proce-
dure, pulling up on the right lever and pushing down on the left lever. Remove Drawer from slide and
cabinet body. Repeat procedure for remaining 5 Drawers.
Note Lever
Release May Be
reversed
Right Drawer Slide
Push Down on
Release Lever
