Page 7
Six Drawer Base Cabinet
Move cabinet into its final position. Fasten
cabinet to wall
STUDS
and/or adjacent cabi-
nets as
required.
Adjacent Cabinet Mount Parts
4 x M6-20 Hex Head Bolts
4 x 6 mm Hex Nuts
STEP 3
Wall Mount Parts
4 x Drywall Screws
4 x Fender Washers
STEP 4
Insert large drawers into cabinet body by extending all 4 slides. Insert the 4
Drawer Slides into these extended slides. Push drawer inward in a gentle
rocking motion. When slides are properly inserted you will hear a clicking
sound.
Close and re-open drawer. Drawer should slide freely. If drawer binds, one
or more slides was probably not correctly aligned during drawer insertion.
NEVER FORCE SLIDES
Installing drawers with double slides can be tricky. If you encounter resistance,
check alignment and repeat above instructions. In some cases it may be easier to
first attach the 2 left slides and then attach the 2 right slides. Slides are released by
pulling the two plastic levers up or down.
If slides are forced, the race that holds the ball bearing may become bent causing
dislodged ball bearings. Loose ball bearings can be set back into the race and the
race can be straightened using a small flat tipped screwdriver.
