CONTROLS
SC17 98861 05/15/01
3-6
1. SOLUTION CONTROL LEVER
Controls solution flow to scrub deck.
To increase flow push the knob forward to
the desired flow.
To decrease flow pull the knob back.
2. BRUSH SWITCH
Controls the scrub brush motor.
To turn scrub brush on, press the top of the
switch.
To turn scrub brush off, press the bottom of
the switch.
3. BRUSH LIFT PEDAL
Raises and lowers the brush.
To lower the brush, push down on pedal
and move to the left.
To raise the brush, lift the lever from its
lowered position.
4. VACUUM SWITCH
Controls the vacuum motor.
To start vacuum motor, press the top of the
switch.
To stop vacuum motor, press the bottom of
the switch.
5. SQUEEGEE LIFT LEVER
Raises and lowers the squeegee.
To lower the squeegee, lift and pull the lever
to the right and then lower.
To raise the squeegee, lift the lever and
push it to the left.
6. BATTERY CHARGE LEVEL INDICATOR
Indicates the charge level of the batteries.
The meter display is divided into 10 vertical
bars. Bars illuminated on the top indicate
full charge. Bars flashing near the bottom
indicate the batteries should be recharged.
Further operation of the machine could
damage the machine or the batteries.
When the machine is left overnight with less
than a full charge, the display may initially
indicate a full charge. It will also indicate a
full charge if the batteries are disconnected,
then reconnected. After a few minutes of
operation the meter will give the correct
charge level.
7. HOUR METER (OPTIONAL)
Records the number of hours the machine’s
brush has been in operation. This
information is useful in determining when to
service the machine.
8. CIRCUIT BREAKERS
Circuit breakers interrupt the flow of power
in the event of an electrical overload. When
a circuit breaker is tripped, reset it by
pressing the exposed button. If a circuit
breaker continues to trip, the cause of the
electrical overload should be found and
corrected.
25 Amp. Protects the scrub
brush motor.
25 Amp. Protects the vacuum
motor.
9. BRUSH REVERSE SWITCH
Reverses the scrub brush motor.
To activate, press the top of the switch.
