Saberz Project
M Chassis Installation Guide
R
ECHARGE
P
ORTS
(RCP
S
)
Version 1.9.5_b
–
September 18, 2022
•
Page 11
-
Since the soldered connections on the RCP are very small and somewhat delicate it is important to protect them
with a thin application of hot glue which will fully secure them. This prevents damage to the small RCP welds
later on during the install process.
Important!
Failure to do this will likely result in the welds breaking from the
movement of the wires during the install!
-
Also curling the green wire before installing the RCP will provide additional (and much-welcome) ease during the
ProffieBoard installation later:
Important!
Before installing the RCP into the chassis, note the RCP opening is situated closer to one end of the RCP
housing. The image below indicates the required orientation in which the RCP needs to be facing. Failure to situate
the RCP as seen below will result in the recharge port hole not lining up with the RCP opening in the hilt!