Saberz Project
M Chassis Installation Guide
P
OWER AND
A
UXILIARY
T
ACTILE
B
UTTONS
Version 1.9.5_b
–
September 18, 2022
•
Page 18
9
Power and Auxiliary Tactile Buttons
The tactile switches need to be installed before installing the battery sled as wires for the AUX switch will be routed
under the batter sled.
Solder 28 AWG BLACK and
YELLOW
wire onto the prongs on one switch, and 28 AWG BLACK and
WHITE
wire onto
the other switch.
-
The white and black set will be used for the PWR button.
-
The yellow and black set will be used for the AUX button.
Important! Before proceeding note the tactile switches need to be installed directly against the inner portions of the
tactile depression as follows:
-
Carefully route the wires through the wire holes (keeping in mind the soldered connections on the tactile
switches are very delicate)!
-
Install the black/white set (for power) in switch the depression closer to the emitter.
-
Install the black/yellow set (aux) in the switch depression further from the emitter.
-
Use a
very
small dab of super glue in the switch holder and carefully press the switches into the holder.
