Saberz Project
M Chassis Installation Guide
A
DJUSTING AND
S
ECURING THE
P
OWER AND
A
UXILIARY
B
UTTONS
Version 1.9.5_b
–
September 18, 2022
•
Page 24
12
Adjusting and Securing the Power and Auxiliary
Buttons
Note: The black rubber O-rings (on the PWR and AUX buttons) which came with your Project M hilt will need to be either
removed or replaced with thinner O-rings when using a chassis with this saber.
The screw seen under the PWR and AUX buttons acts as a “plunger” and will need to be adjusted by turning the screw (a
specific number of turns) to set the screw plunger at the optimal distance above the tactile switches on the chassis.
Start out with the following general suggested distance settings and adjust as needed:
Red button
–
8 half-turns outward
Silver button
–
7 half-turns outward
Once you have found the best position for optimal button presses it is important to secure the plunger screw in place as
otherwise it will loosen over time which causes the plunger screw to no longer properly depress the tactile switches on the
chassis in the hilt. We recommend using the (removable grade) of Loctite 222 purple as it is not permanent and will securely
keep your plunger screw from loosening up over time and usage.
