Front wing screws:
1100 [MH124]:
Insert 1 flat head screw M6x35mm in the
•
central hole without tightening.
Insert 1 M6x30mm in the front and rear
•
hole without tightening.
Proceed to tighten the screws.
•
873 [MH119]:
Insert 1 flat head screw M6x50mm in the
•
front and central hole without tightening.
Insert 1 M6X45mm in the rear one
•
without tightening.
Proceed to tighten the screws.
•
790 [MH124]:
Insert 1 flat head screw M6x35mm in the
•
central hole without tightening.
Insert 1 M6x30mm in the rear and front
•
hole without tightening.
Proceed to tighten the screws.
•
679 [MH109]:
Insert 1 flat head screw M6x25mm in
•
each hole without tightening.
Proceed to tighten the screws.
•
633 [MH114]:
Insert 1 flat head screw M6x30mm in the
•
front and central hole without tightening.
Insert 1 M6x25mm in the rear hole
•
without tightening.
Proceed to tighten the screws.
•
Board connection:
Insert the proper screws for the board from the upper side.
•
Check that all screws are inside the bushing before tightening.
Proceed to tighten the screws.
•
Lithium grease
[MHW033]
Front wings screws:
surf foil manual
1
2
Match the fuselage [MH112]:
Insert 1 socket head screw M6x20mm and 1 washer
•
6.2x 9.9 x 1mm in each hole without tightening.
Proceed to tighten the screws.
•
Always keep the threaded holes and every connection
between carbon (mast and wings) and aluminum
(fuselage) clean and greased with "lithium grease"
[MHW033] to avoid and prevent oxidation and
corrosion due to salt water.
Stabilizers screws [MH108]:
Insert 1 flat head screw M6x20mm in the front hole
•
without tightening.
Insert 1 flat head screw M6x16mm in the rear hole
•
without tightening.
Proceed to tighten the screws.
•
Check the latest version of this manual
Check the latest version of this manual
THE SCREWS MUST BE TIGHTEN BETWEEN 8 AND 9 Nm
THE SCREWS MUST BE TIGHTEN BETWEEN 8 AND 9 Nm
THE SCREWS MUST BE TIGHTEN BETWEEN 8 AND 9 N
THE SCREWS MUST BE TIGHTEN BETWEEN 8 AND 9 N
THE SCREWS MUST BE TIGHTEN BETWEEN 8 AND 9 N
THE SCREWS MUST BE TIGHTEN BETWEEN 8 AND 9 N
THE SCREWS MUST BE TIGHTEN BETWEEN 8 AND 9 Nm
THE SCREWS MUST BE TIGHTEN BETWEEN 8 AND 9 N
