EN
33
Fig. 2 / Abb. 2
CONTROL INSTALLATION
Separate the front of the controller
from the rear plate by using a
screwdriver to press the locking
tongue on the top of the controller.
Place the rear plate on the wall and
mark the mounting holes.
Drill the holes, insert the screw plugs
in the wall and fasten the plate with
screws.
Make the electrical connections as
shown in the wiring diagram on the
following page.
ATTENTION!
To carry out the electrical con-
nections to the
T–MB
control,
remove the insulated protection
device from the clamp.
Once the electrical connections
are completed, replace the pro-
tection device, as in
Fig. 2
.
Reassemble the front part of
the
control, placing the two flaps
located on the lower side and then
close the control, by making the
upper flap click.
84 mm
60 mm
1
2
3
