31
EN
Using the configuration for 230 Vac actuators,
position the cover on the M17 clamp.
14 T-MB WALL CONTROL COD.
9066331E - GENERAL NOTES -
The T-MB is a wall-mounted control that can be con-
nected to cassette or fan coil units equipped with
the MB electronic board and connected to a RS485
network.
With the control it is possible to set and visualize as
follows (see picture 14.1) :
1. oN/oFF of the unit
2. Fan speed
3. Temperature set
4. operating mode
5. Cooling
6. Heating
7. Fan only
8. Automatic operating mode
9. Active heater signaling
10. Ventilation set
11. Environment temperature measured / SET / oFF
12. Clock
13. Active timer
14.1
14.2
LxWxH (mm) : 72 x 110 x 25
Read carefully the following instruction
booklet before installation and control
usage
14.1 Control Installation
Separate the front of the control from the rear plate
by using a screwdriver to press the locking tongue
on the top of the control.
Place the rear plate on the wall and mark the mount-
ing holes.
drill the holes, insert the screw plugs in the wall and
fasten the plate with screws.
Make the electrical connections as shown in the wir-
ing diagram on the following page.
Summary of Contents for QCV-MB
Page 3: ...3 IT da p 5 EN from p 23 ...
Page 59: ......
