SCLO 200M
Date: Dec 23.2020 Version 1.03
Public version
Product Manual
13
of 24
SABIK Oy
· BOX19 · FI 06151 Porvoo · Tel358 -19- 560 1100 · www.sabik.com
5.1.5. Pages
On the pages you will find information about the lantern, change settings and send commands. Observe that if
your lantern do not have a specific module installed, then there is no information about that module.
DEVICE STATUS
Here you will find information about the Light, Power, Temperature, Position, Counters and Engineering values.
You cannot make any changes to the lantern from this page. Observe, that some values/settings may not be
available in your lantern.
Light
Light Status:
Shows the current light status, Active/Idle
Lantern Health Status:
Any possible error or warning is shown in the health status
Photocell Value:
Shows the real-time photocell value
Day-to-Night:
Latest transition time from day mode to night mode
Night-to-Day:
Latest transition time from night mode to day mode
Power
Battery Voltage
Real time battery voltage
Battery Voltage Max
Maximum battery voltage during the last 24h
Battery Voltage Min
Minimum battery voltage during the last 24h
Battery Voltage Avg
Average battery voltage during the last 24h
Power Consumption:
Real time power consumption (measured only when light is lit)
Temperature
Temperature
Real time temperature
Max. Temp. 24h
Maximum temperature during the last 24h
Min. Temp. 24h
Minimum temperature during the last 24h
Avg. Temp 24h
Average temperature during the last 24h
Position (If GPS module installed)
GPS Latitude
Latest measured latitude position
GPS Longitude
Latest measured longitude position
GPS Time
Time of last fix
GPS Accuracy
GPS horizontal dilution of precision
Counters
Operating Hours
Total illumination time
Power Cycle Counter:
Indicates the number of times power has been removed from lantern
System Reset Counter:
Number of reboots
Engineering
Measured LED Current
Measured LED Voltage
Lantern Tilt Angle
LED Max Intensity
