34
S
ECTION
E
IGHT
: U
SING
GRQ2 R
EMOTE
S
OFTWARE
adjustments made on the Graphi-
Q front panel WILL be displayed
on the Remote Control screens.
In addition, any of these adjust-
ments, alone or in combination,
can then be saved to any of the
memory locations from #2 to #20.
To accomplish this, open the
Stored Preset screen, and select
the Program Number/Program
Name field. Type in the name you
wish to give your memory, then
choose SAVE. You can rename
your configuration without resaving
all the parameter settings by typ-
ing a new name and pressing the
ENTER key.
If you save a program without naming it, the default name (e.g., Prog 1) will change to an all upper case
version of the same name (e.g., PROG 1).
Programs 2 through 20 will only allow remote control of the Graphi-Q2, and front panel adjustments made
when the remote control is in command will be ignored (unless you have chosen Mixed Control see section
8.2.10). Loading Preset #1 will return control to the front panel, and any physical adjustments made on
the front panel while it was disconnected will be implemented at that time.
When loading or saving configurations, the Stored Presets screen will stay open until you close it. This
allows comparisons between different configurations by loading them to active memory and auditioning
the results.
8.6.1.2. Summary of Stored Preset Protocols
To summarize the control and indicator protocols of the Graphi-Q:
1.
Whenever Preset 1 is selected, the front panel settings will be absolute indicators of parameter
settings, and manual adjustments will be implemented immediately. The Remote Control screens
will display these manual adjustments, but remote control will be disabled. The Curve Display on
your monitor will indicate “Preset #1 - Front Panel in Control”.
2.
Any adjustments made manually from the front panel when Preset 1 is loaded may be stored and
named in any Preset from #2 to #22.
3.
Presets 2 through 20 disable front panel control, in favor of Remote Control. All settings may be
adjusted using the Remote Control software only. Updated or altered settings may be stored (using
the same or a new name) in any location from #2 to #20.
4.
For Presets 2 through 20, settings made by the Remote Control will be reflected by some but not all
front panel settings (on the actual Graphi-Q unit), but all WILL be displayed on the Remote Control
screens. Adjusting the Graphi-Q front panel settings will NOT affect the audio signal, nor will the
Remote Control screens reflect these settings.
5.
Changing programs can be done at any time, in the middle of an audio program if needed, PROVIDED
THERE IS NOT A BIG DIFFERENCE IN DELAY SETTINGS FROM ONE MEMORY TO THE NEXT.
Loading a new preset with a different delay setting will cause a temporary pitch shift in the audio
program if the change is made during program.
6.
An X will appear to indicate last saved and last loaded presets. Clicking in the program name region
will allow you to type in any name for your memory, up to 14 characters long. The number of the last
saved and loaded presets will appear at the bottom of the main Remote Control screen.
7.
The controlling interface (front panel or remote) will be indicated at the lower right of the main Remote
Control screen at all times.
8.
See
Section 6.8
for information about changing default values for front panel operation for
parameters that are not accessible without Remote Control.
