34
Sabine Smart Spectrum
®
Wireless
© 2011 Sabine
, Inc.
Fig. 10e: Program PRESET LOADED
10. PRoGRAM SAVE & RECALL
Most wireless microphone systems provide control of one or two settings (RF
channel and maybe gain). With so little to remember, the ability to save and recall
system settings has not been necessary. With the Sabine Smart Spectrum®
series, however, you get a very sophisticated processor with a variety of adjust-
able parameters. The ability to save and recall your carefully programmed setups
can be a tremendous time-saver. Your Sabine receiver allows you to store and
recall up to 10 different presets.
10.1. Saving a Preset
To save a program, press the SELECT button. The last preset used (numbered
01 - 10) will be shown in the LCD Display (see Fig. 10b). If you want to replace
an existing program, press SELECT until you reach that program’s number. Then
press the SAVE button. The function display will show “YES?”. If you are ready to
save, immediately press the SAVE button again, and your settings will be saved
to that program number. The message PRESET SAVED will be shown for four
seconds in the text display to confirm this action, as the LCD Display continues
to show the number (01-10) of the preset (see Fig. 10c). After four seconds, the
LCD Display will revert to an indication of the RF channel.
10.2. Loading a Preset
Loading a program is just as easy. Press SELECT until you locate the program
number you wish to load. Press LOAD. The function display will show “LOAD
YES?” (see Fig. 10d). Immediately press the LOAD button again and your new
program, including all the parameters, will be loaded for that channel. The mes-
sage PRESET LOADED will appear in confirmation (see Fig. 10e).
10.3. naming a Preset
Presets, channels and receivers can be named using the Sabine True Mobility
Remote Software. Refer to Section 13 for details.
10.4. Power off Memory
The receiver retains in memory all settings in effect at the time of being powered
off, and returns to those settings when powered on.
Program Save & Recall
Fig. 10a: Program Front Panel Buttons
Fig. 10b: Program SAVE YES?
Fig. 10d: Program LOAD YES?
Fig. 10c: Program PRESET SAVED
PRESET noTES
1. Preset 01 is the System Default (SYSDEF on the front panel) and you cannot
save a preset here. Load this setting when you want to return the receiver to the
factory default settings.
2. Preset names will appear on the LCD only after you name the preset using the
remote control software.
Summary of Contents for SWM6000
Page 2: ......
