Assembly - Page 7
ASSEMBLY
Check Machine Safety System
Perform safety system check to make sure the
electronic safety interlock circuit is functioning properly.
Perform all six Tests. (See Testing Safety System in the
Operating section)
Checking Tire Pressure
1. Check tires for damage.
2. Check tire pressure with an accurate gauge.
3. Add or remove air, if necessary:
c
CAUTION: Explosive separation of a tire and
rim parts can cause serious injury or death:
- Do not attempt to mount a tire without the
proper equipment and experience to perform
the job.
- Always maintain the correct tire pressure.
Do not inflate the tires above the
recommended pressure. Never weld or heat a
wheel and tire assembly. The heat can cause
an increase in air pressure resulting in a tire
explosion. Welding can structurally weaken or
deform the wheel.
- When inflating tires, use a clip-on chuck and
extension hose long enough to allow you to
stand to one side and NOT in front of or over
the tire assembly.
- Check tires for low pressure, cuts, bubbles,
damaged rims or missing lug bolts and nuts.
Tire Size
Pressure-kPa (psi)
Front: 16 x 6.5
97 kPa (14 psi)
Rear: 23 x 9.5
83 kPa (12 psi)
