8.
Click “Finish”.
Windows will now begin formatting and initializing the disk:
9.
Open
“My Computer”
and
verify
that the drive shows up properly:
If the drive already has data on it you can skip the previous step.
1.
Check
the
“Device Manager”
to make sure that the
“USB Mass Storage Device”
driver appears under the
“Universal Serial Bus Controllers”
section. Also
check
that the drive shows up under
“Disk drives”
as a
“(Hard
drive model number) USB Device”.
There should be no error message in your Device Manager, such as a bold
?
or
! :
Summary of Contents for EC-UEIS7
