37
0171-761-EN
·
Repeat the procedure for discharge and
oil pressures.
·
Repeat the procedure for temperature in-
puts, if they have been calibrated.
·
Select
P.Band
and press the
RE-
SET
key to
set the factory values (FAC in the dis-
play).
·
Switch off the power supply to the
UNISAB S-Control. Switch it on again
right away and the UNISAB S-Control
will be ready to operate.
The actual limit values should then be coded
in (See the chapter entitled
Changing pa-
rameters
).
Summary of Contents for UNISAB S-Control
Page 1: ......
