Page # 10
877 1st Ave. N.W. | Sioux Center, IA 51250 | Toll Free: 1.866.722.1488 | siouxautomation.com
OPERATION
REPLACEMENT PARTS
READ complete manual CAREFULLY
BEFORE attempting operation.
877 1st Ave. N.W. | Sioux Center, IA 51250 | Toll Free: 1.866.722.1488 | siouxautomation.com
OPERATION
REPLACEMENT PARTS
READ complete manual CAREFULLY
BEFORE attempting operation.
• Be sure the inside of the mixer is clear of any obstruction before operating and that all shields are in place.
This includes any truck and driveline shields. Repair or replace any damaged or missing shields. Exposed
shafts can grab hands and clothing and cause severe injury or death.
• Use caution when working around the discharge area. Stay clear of power chute & slide tray. These are
controlled from the cab and could operate without warning, creating pinch points which could cause severe
injury or death. Always stop the truck’s engine and remove the trucks ignition key before working close to or
near the discharge area.
• Never attempt to release jammed materials or clean materials from any area of the mixer or discharge
chute without stopping the engine first. Moving parts can be hidden by materials, and stopped parts
can start unexpectedly, causing severe injury. Always disengage the PTO driveline so that the mixer cannot
be accidentally turned on before attempting to remove jammed material or to clean.
• Never put arms or feet inside unit, power chute, or near discharge door opening, nor climb on or in the mixer
while it is running. NEVER allow anyone to position themselves over or near the top of the mixer while it is
running. Rotating augers and sprockets can grab clothing or create pinch points which can cause severe
injury or death to the operator or bystanders. Always disengage the PTO driveline, stop the truck engine,
and remove the ignition key so that the mixer cannot be accidentally turned on while inspecting, servicing,
repairing, or cleaning.
• Following operation disengage PTO, set brakes, shut off engine and remove the ignition key.
• Store unit in an area away from human activity.
• Do not park equipment where it will be exposed to livestock for long periods of time. Damage and
livestock injury could result.
• Do not permit children to play on or around stored unit.
• Make sure all parked machines are on a hard, level surface and engage all safety devices.
• Wheel chocks may be needed to prevent unit from rolling.
FOLLOWING OPERATION
HIGHWAY AND TRANSPORT OPERATIONS
• If equipment is going to be transported on a public highway, always follow state and local regulations
regarding safety and auxiliary lighting. Be sure to check with local law enforcement agencies for your own
particular regulations. The end user is responsible for federal, state and local vehicle safety regulation
compliance (ex: requirements for weight, lighting, etc.).
• Adopt safe driving practices:
- Always drive at a safe speed relative to local conditions, ensure that your speed is low enough for an
emergency stop. Keep speed to a minimum.
- Reduce speed prior to turns to avoid risk of overturning.
- Always keep the truck’s transmission in gear to provide engine braking when going downhill.
Do not coast.
-
Do not drink and drive!
SAFETY
Summary of Contents for TURBO-MAX 6190
Page 64: ......
