SAC TURBO-MAX 6190, Operator And Parts Manual

Page # 18

877 1st Ave. N.W. | Sioux Center, IA 51250 | Toll Free: 1.866.722.1488 | siouxautomation.com

OPERATION

REPLACEMENT PARTS

READ complete manual CAREFULLY

BEFORE attempting operation.

877 1st Ave. N.W. | Sioux Center, IA 51250 | Toll Free: 1.866.722.1488 | siouxautomation.com

OPERATION

REPLACEMENT PARTS

READ complete manual CAREFULLY

BEFORE attempting operation.

HYDRAULIC FILTRATION





•









































            





 

 

 

 



 



                  



 

                   



 













 FILTER SHOWN:

FORCE AMERICA

# F3653-10C

BRAND NAME                    PART NUMBER

SAC             

HYD1A9021

FORCE AMERICA  

F3653-10C

NAPA 

  1551

ZINGA 

  AE10

Auxiliary Circuit Filter

Auxiliary Circuit Filter

Located on the return line on the right hand side of the hydrualic tank is the auxiliary oil filter.  The filter is a “spin-on” type 

of filter that will need replacement.  

Replace this filter element after 50 hours of break-in use and every 500 hours 

thereafter.

Once hydraulic oil has circulated through the 

manifold valve and the hydraulic cooler, it 

exits into a filter assembly located near the 

hydraulic tank.  This assembly filters all of the 

oil supplied in the auxiliary pump circuit.  The 

filter is a ‘spin-on’ type of filter.  The filter is 

removed by turning the filter body counter-

clockwise until it is free from the filter hous

-

ing.  This filter will require periodic service 

and replacement. 

Auxiliary Circuit 

Filtration

Filter Replacement (Auxiliary Circuit Filter)

 1.  Make sure that the filter housing and filter are clean and free of any debris and other contaminates.

 2.  Make sure that the replacement filter is the correct type for the application.

 3.  Place a large drain pan or pail underneath the filter housing.

 4.  Using a filter wrench, remove the filter by turning the filter body counterclockwise until it is free from the housing.

 5.  Allow sufficient time for any oil in the surrounding hoses to drain into the pan or pail.  Allow oil to drain out of the       

      filter itself.

 6.  Visually inspect the condition of the filter to determine if the hydraulic system is in need of further servicing.

 7.  Dispose of the used oil in an environmentally safe manner.

 8.  Apply a thin coat of clean oil to the top gasket of the filter to ensure a smooth and tight seal with the filter housing.

 9.  Turn the filter body clockwise and 

hand tighten

 the filter to the filter housing.  

10. Top off the hydraulic reservoir with oil if necessary.

11. Follow all instructions as outlined in the operator’s manual and startup the hydraulic system and run.  Check for and  

       repair any leaks that may arise.