1
2
1
4
4
4
4
2
2
3
2
102
CYLINDER HEAD / VALVES
CYLINDER HEAD INSTALLATION
Clean the cylinder head gasket surface of any gasket material.
NOTE
Do not allow dust and dirt to enter the cylinder.
Install the dowel pins, a new cylinder head gasket, the 0-rings
and collars.
Install the cylinder head and a new head cover gasket.
Position the cylinder head cover with its arrow (1) facing the
exhaust side.
Install the sealing washer (2), copper washer (3) and nuts (4)
in the proper locations.
Tighten the cap nuts to the specifi ed torque.
TORQUE: 10-12 Nm
Install the muffl er in the reverse order of removal.
TORQUE
Exhaust pipe joint nuts (1): 10-12 Nm
Tighten the intake manifold bolts (2).
TORQUE: 10 Nm
NOTE
Make sure that the O-ring is positioned properly.
Summary of Contents for madass
