40
3
3
4
Checking/replacing the lining of the rear brake-shoes
Checking the lining thickness:
CAUTION
Make sure the minimum lining thickness is observed.
- Visually inspect the brake calliper (1).
- Check the minimum lining thickness.
Minimum lining thickness (A): 1.5 mm
If the lining thickness is less than the minimum:
replace the brake lining.
- Check the brake disk for wear and wobble.
Replacing the brake lining:
NOTE
The brake linings may only be replaced in pairs.
Use heatproofed lubricant e.g. copper paste for mechanical
movable parts.
Use screw-lock e.g. Loctite 242 for brake screws.
- Unscrew the bolts (3 )and remove the brake calliper (1).
- Remove the screws (4).
- Remove the brake linings (5).
- Insert the new brake linings (5) and install the brake capiller
with screws (4).
Tightening torques
Screws (4): 30-35 Nm
- Reassemble in reverse order.
Tightening torques
Bolts (3): 30-35 Nm
WARNING - RISK OF ON-ROAD ACCIDENT
Operate the brakes several times, until the brake linings
make contact.
- Check the operation.
MAINTENANCE
5
5
A
1
A
2
Summary of Contents for madass
