(5) FLOAT CHAMBER
6
6
6
6
18 mm
4
2
1
3
72
FUEL SYSTEM
Install the fl oat valve (1), fl oat (2) , and fl oat arm pin (3).
FLOAT LEVEL INSPECTION
Measure the fl oat level with the carburetor inclined 15—45°
from vertical so that the fl oat tang just contacts the fl oat valve.
FLOAT LEVEL: 18.0 mm
TOOL: VERNIER CALLIPER
Make sure the fl oat moves smoothly.
Install a new O-ring (4) in the carburetor groove.
Install the fl oat chamber (5) and tighten the screws (6).
Summary of Contents for madass
