Publication Part No. S2080-4980/0
www.sachtler.com
1.
Apply the horizontal and
vertical brakes and hold
the head firmly with one
hand.
Mounting the Head and Setting Connector Tension
2.
Lift the SpeedLevel Lever
as shown all the way to the
top.
3.
Lower the head onto the Bowl
Connector and carefully lower
the SpeedLevel Lever.
4.
To set the connector tension
, raise the tripod so the head is at eye level.
5.
Lift the SpeedLevel Lever on the head and hold with “S triangle” aligned to
the mark on the body.
45°
60°
The tension is correct when the SpeedLevel Lever is released and falls between approximately 60° and 45° (30 mm to
50 mm (1” - 2”)) from the body of the head as shown in the diagram below.
If the lever falls back against the body the Bowl Connector is too loose, repeat steps 5 and 6.
CAUTION! Try and lift the head to ensure the head is fully secured
to the tripod.
Approximately 45° to 60° from the body (30 mm to 50 mm
(1 in to 2 in)) from the body.
6.
Firmly, finger tighten the Bowl
Connector by pressing up and
turning clockwise to remove all
clearance.
CAUTION! Push the SpeedLevel Lever fully closed against the head before use.
