Ver 1.0
11
La ventaja de seleccionar un dP diferente de cero es que se puede redimensionar el caudal si hubiera
pérdidas en la instalación y permitir un ahorro de energía, pudiendo funcionar la electrobomba a bajas
revoluciones cuando los flujos requeridos son bajos.
Los posibles valores configurables de dP son de 0 a 1,0 bar, salvo limitaciones automáticas (véase párrafo
6.1.1.1).
El PWM pasa de la condición de Stand By al encendido de la electrobomba después de que la presión en la
instalación ha descendido por debajo de SP – dP – rP (véase párrafo 6.1.1.1).
6.1.3.6
Ft: Configuración del umbral de flujo bajo (valor preconfigurado 15)
El sistema PWM está dotado de un sensor de flujo. Cada vez que la electrobomba está apagada se efectúa
una nueva puesta a cero. El PWM apaga la electrobomba cuando el flujo leído es inferior a “Ft”. En otras
palabras, el umbral de flujo bajo es un margen de tolerancia en la lectura de ZF que asegura que la
electrobomba se apague.
Para comprobar que los apagados con correctos es suficiente comparar el flujo "UF" (véase párrafo 6.2.2.1
UF: Visualización del flujo) leído con los grifos cerrados y la electrobomba en funcionamiento con el
parámetro configurado "Ft".
6.1.3.7
AE: Habilitación de la función anticongelante (valor preconfigurado 1)
Hace girar el grupo motor-rodete para evitar bloqueos mecánicos.
Cuando la funcionalidad anticongelante está habilitada, si el PWM mide una temperatura muy baja con
riesgo de congelación, comienza automáticamente a hacer funcionar la electrobomba a bajos números de
revoluciones. Mantener el agua en movimiento reduce el riesgo de que se forme hielo en la bomba.
También para el PWM, disipando energía se reduce el riesgo de rotura por hielo.
6.2 Parámetros de visualización
Desde el estado de funcionamiento normal, pulsando el botón MODE se visualizan las siguientes
magnitudes:
6.2.1 Parámetros para el usuario (botones de acceso MODE)
Desde el estado de funcionamiento normal (Sb o Go en la pantalla), pulsando el botón MODE en la pantalla
aparece “Fr”.
Entonces es posible visualizar todas las siguientes magnitudes en sucesión, pulsando cada vez el botón
MODE.
6.2.1.1
Fr: Visualización de la frecuencia de rotación actual (en Hz)
6.2.1.2
UP: Visualización de la presión (en bar)
6.2.1.3
UE: Visualización de la versión del software instalado en el equipo
6.2.2 Menú MONITOR (botones de acceso SET & -)
Desde el estado de funcionamiento normal, mantenga pulsados simultáneamente los botones SET y -
(menos) hasta que en la pantalla aparezca “UF”.
Entonces es posible visualizar todas las siguientes magnitudes en sucesión, pulsando cada vez el botón
MODE.
6.2.2.1
UF: Visualización del flujo
Visualización del flujo instantáneo en escala interna no calibrada.
6.2.2.2
ZF: Visualización del cero flujo
Visualización de la lectura del sensor de flujo en el que se ha efectuado la puesta a cero (con la
electrobomba apagada).
Durante el funcionamiento normal, el PWM utilizará este parámetro para apagar la electrobomba.