3
SAFETY EQUIPMENT AND PRECAUTIONS
3-4
004AZ011B
3.2
SAFETY RULES FOR HANDLING
D0003276_00
SAFETY
INSTRUCTIONS
Only specially trained authorized personnel may lift and handle the device.
No one should be near the hanging load or within the range of action of the lift equipment while the electronic
equipment is being lifted and handled.
The loads may be handled manual, where possible, only by personnel properly trained on how to lift and handle,
observing all current safety standards and laws.
The manufacturer shall not be held responsible for any personal injury or property damage resulting from failure
to observe current safety standards regarding lifting and handling materials in the user’s facility.
3.2.1 LIFTING
To safely and correctly lift and handle the machine always:
- use the most suitable lifting equipment with an adequate lift capacity;
- check the safety device of the hook;
- cover all sharp edges with rags and/or cardboard;
- make sure the lift devices do not damage electronic equipment components.
Before lifting:
- make sure all personnel is safely away and that no one can enter the area where the machine is being moved;
- make sure the load is stable;
- gradually lift in a vertical manner in order to avoid swaying and irregular movements.
3.2.2 MOVEMENT
While being moved, the load must always remain perfectly horizontal regardless of the type of lift equipment used.
To facilitate the lifting and handling operations use bars, levers and ramps at a safe distance away. Never use only
hands.
The person in charge must:
- have a clear view of where the machine is to be moved;
- give instructions to the crane operator from a position where he/she can be clearly seen;
- stop immediately if dangerous conditions arise.
3.2.3
PLACING THE LOAD
Before placing the load make sure the floor is perfectly level and its load bearing capacity is suitable for the weight
of the machine.
Do not place the loads in areas where they may create potential dangers or prevent access to equipment and/or
emergency exits.
The load must be placed on the cross-bars provided so that it is stable and the slings can be easily removed.
Do not place worn containers or those with protruding material on top of it.
Do not stack materials at dangerous heights where they risk falling down.
Summary of Contents for CVS Series
