8
Press the OK button to start the descaling cycle.
,
The machine dispenses the entire descaling solution at regular intervals through the steam
wand and dispensing spout (this takes approximately 25 minutes).
9
Wait until all of the descaling solution has been dispensed. Remove and empty the container.
10
Remove and empty the drip tray. Slide the drip tray back into the machine.
11
Rinse the water tank and fill it with fresh water up to the CALC CLEAN indication.
Slide the water tank back into the machine.
12
Place the container back under the steam wand and dispensing spout.
13
Press the OK button to start the rinsing cycle (this takes approximately 4 minutes).
,
The display shows the following icon to indicate that the rinsing cycle is finished. (Fig. 18)
14
The display shows a tick icon.
15
Rinse the water tank and fill it with fresh water up to the MAX level. Slide the water tank
back into the machine.
16
Press the OK button to end the descaling cycle.
17
Place a container under the steam wand and dispensing spout.
18
The display shows the following icon to indicate that the machine is heating up (Fig. 19).
,
The machine performs an automatic rinsing cycle.
19
Remove the container. Remove and empty the drip tray. Slide the drip tray back into the
machine.
20
Place the AquaClean filter back in the water tank. Reinsert the classic milk frother.
21
Remove and rinse the brew group see chapter ‘Cleaning and maintenance’, section ‘Clean the
brew group’.
The machine is now ready for use.
Interruption of the descaling cycle
Once the descaling cycle has started, you must complete it till the very end without turning off the
machine. In case you get stuck during the cycle or in case of power failure or accidental
disconnection of the power cord, you can exit by pressing the on/off button. If this occurs, empty
and rinse carefully the water tank, then fill it up to the CALC CLEAN level. Follow the instructions
in chapter ‘First installation’, section ‘Manual rinsing cycle’ before brewing any beverage. If the cycle
was not completed, the machine will require another descaling cycle to be performed at your
earliest convenience.
Cleaning and maintenance
Cleaning the brew group
Clean the brew group once per week. Check the online manual for more detailed information
about the monthly cleaning of the brew group.
1
Remove the coffee grounds container and open the service door.
2
Remove the coffee residues drawer (Fig. 20).
3
To remove the brew group, press the lever and pull the brew group out of the machine
(Fig. 21).
4
Carry out maintenance to the brew group as described in the online user manual
5
Make sure that the lever is in contact with the base of the brewing unit (Fig. 22).
ENGLISH
11
4219_460_2735_2_DFU-Simple_A5_v1.indd 11
15/12/15 09:53
