English
5
58
5.4
Connection to the electric
network
The Maintenance Technician, who is responsible for
the installation of the machine, must ensure that:
• the electric system complies with current safety
regulations;
• the supply voltage corresponds to that indicated on the
data plate.
If in doubt, do not proceed with the installation and
ask qualified and authorized personnel to check the
system accurately.
Also make sure that the electrical system the appliance
is connected to has the maximum load capacity
required, as indicated on the data plate.
G
Power cord type H07RNF sec. 3x2.5 mm²
Insert the power cord (G) into the hole A.
G
Power cord type H07RNF sec. 3x2.5 mm²
N
Neutral
L1
Phase
T
Ground
Depending on the current regulations of the Country
where the machine operates, the cable connecting the
electric line has to be pre-set or equipped with an
all-pole switch (with a minimum contact opening of 3
mm), (or with a plug in accordance with the same
regulations).
• The all-pole switch must suit to machine input and be able
to detect all voltage polarities.
• Check that the electrical cables of the system are
proportioned to machine input.
Connect the appliance to the mains by means of the
power cord (G).
Make sure that the electrical plug is easily accessible
even after installing the machine.
The electric socket which the appliance is connected
to must be easily accessible for the user, so that the
user will easily disconnect the appliance from the
electric mains when necessary.
If damaged, the power cable must be replaced by the
Maintenance Technician only.
5.5
Mounting the Spoilers
Insert the left side spoiler as shown in the figure.
Do the same for the right side spoiler.
