2
Turn the milk dispensing unit upside down and hold it firmly in your hand.
Pull the milk tube off the rubber support.
2
1
3
Press the release buttons on the milk frother and remove the milk frother
from the the rubber support.
4
Pull the milk frother connector out of the milk frother.
5
Rinse all components under a lukewarm tap.
Reassembling the milk carafe
1
To reassemble the milk froth dispensing spout, follow steps 2 to 4 of
'Disassembling the milk froth dispensing spout' in reverse order.
2
Place the milk froth dispensing spout back into the top of the milk carafe.
3
Place the top of the milk carafe back onto the milk carafe.
Note: Before you place the milk froth dispensing spout back into the top of
the milk carafe, move the pin inside the top to the correct position. If this pin
is not in the correct position, you cannot place the milk froth dispensing
spout back into the top of the milk carafe.
Monthly cleaning of the milk carafe
Only use SAECO milk circuit cleaner CA6705 for this cleaning cycle.
20
English
