21
SAFETY REGULATIONS
3
SAFETY REGULATIONS
All electrical parts must be kept dry, as
the machine may short circuit on contact
with water. Steam and boiling water can
cause burning. Always point the steam
or hot water jet away from any part of
the body and be careful when touching
the steam/hot water nozzle as it may be
hot: danger of burning.
Use of machine
The machine must not be used for anything
other than its intended purpose.
The coffee machine is designed exclusively
for domestic use.
Technical alterations or misuse are strictly
forbidden owing to the risks that they
involve.
The coffee maker must be used by adults
only.
Electrical requirements
The coffee machine must be connected to
a suitable wall socket.
The voltage used must be that indicated
on the rating plate.
Mains cable
The coffee maker must not be used if the
mains cable flex is defective.
If a plug or cable is defective it must be
changed immediately by a qualified
specialist.
Do not locate the mains cable over hot
surfaces or round sharp corners and keep
it away from oil.
Do not carry or pull the machine by the
mains cable.
Do not unplug the machine by pulling the
mains cable or with wet hands.
Do not allow the flex to dangle from a shelf
or table.
Safeguarding others
Ensure that the machine is out of the reach
of children.
Children are not aware of the risks involved
in electrical appliances.
Burning precautions
Always point the steam/hot water jet away
from you.
Always use the correct handles or knobs.
Only touch the nozzle in the part where it
has been insulated for your protection.
Do not remove the filter holder while the
machine is in use.
While the machine is warming up, hot water
may drip from the coffee outlet.
Location
The machine must be positioned in a safe
place where it cannot be knocked over or
cause injury.
Hot water or steam may leak, causing
possible burning.
Do not use the coffee machine outdoors.
Do not place the machine near hot surfaces
or naked flames as this may damage or
melt the cover.
Cleaning Instructions
Before cleaning the machine, all switches
must be in the “off ” position, and the
machine must be unplugged from the wall
socket.You must wait for the machine to
cool down.Never immerse the machine in
water.It is strictly forbidden to tamper with
the inside of the machine.
Summary of Contents for SIN 007
