DISASSEMBLY TO REPLACE THE BLADES AND THE HAMMER INSERTS
Remove the ignition key before proceeding
-The hollow hexagonal screws of the blades and hammer inserts are mounted in the facture using
LOCTITE normal
243
. Use the appropriate wrench that is in good condition to remove them.
-Open the chute as described on page 25.
-Remove the screws from blades and inserts. (For the assembly later on, only use new and
degreased
screws).
-Clean the contact surfaces of the blades and the inserts clean at the base
(1)
as well as the wall
(2)
.
Maintenance and Service
-Install identical or newly ground blades.
IMPORTANT:
the blades must be ground by a professional using specific tools, and not with a grinding disc. Make
sure tha 35° angle of the cutting edge is respected. The minimal lengt of
A
should not be smaller than 50 mm after
grinding. (The length of a new blade is 60 mm).
(next)
Summary of Contents for GS/TIGER 25D
