SAEVO 40L, Owner'S Manual

16

PRECAUTIONS, RESTRICTIONS AND WARNINGS

Transportation, storage and operation

This equipment must be transported and stored observing the following directions:

- Avoid falls and impacts;

- Keep it dry, do not expose it to rain, water drops or wet floor;

- Keep it away from water and direct sunlight, and in it original wrapping;

- Don’t move it over irregular surfaces, protect it from rain and observe the maximum stack quantity

specified in the packaging;

Environmental condition for transportation or storage:

- Room temperature range for transportation or storage -29ºC to +60ºC.

- Relative humidity range for transportation or storage 20% to 90%.

- Atmospheric pressure range 500hPa to 1060 hPa (375 mmHg to 795 mmHg).

Environmental condition for storage (among the operations):

- Room temperature range for storage -10ºC a +55ºC.

- Recommended room temperature range +15ºC a +30ºC.

- Relative humidity range for storage 30% a 75%.

- Atmospheric pressure range 700 hPa to 1060 hPa (525 mmHg to 795 mmHg).

Environmental operation condition:

- Room temperature range for funct10ºC to +40ºC.

- Recommended room temperature range +21ºC to +26ºC.

- Relative humidity range for functioning 30% to 75%.

- Atmospheric pressure range 700 hPa to 1060 hPa (525 mmHg to 795 mmHg).

- Operation altitude: ≤2000m.

Attention 

The Equipment maintains its condition of safety and efficacy, provided that it is maintained

(stored) as mentioned in this instruction of use. Thus, the equipment will not lose or alter

its physical and dimensional features. 

Sensitivity to environmental conditions in normal situations of use

The  equipment  has  been  planned  not  to  be  sensitive  to  interference  such  as  magnetic  fields, 

external electrical factors, electrostatic discharge, pressure or variance of pressure, provided that 

the equipment is installed, maintained, clean, preserved, transported and operated as per this 

instruction for use.

Precaution and warnings “during the installation” of the equipment

- This equipment can only be unpacked and installed by an Alliage authorized technician.

- Check that the socket in which the device will be connected has a ground connection. According to

the ABNT standard, this is essential for the safe operation of the system.

- Install the equipment in a place where it will not be damaged by the pressure, temperature, humidity,

direct sunlight, dust, salts.

- The equipment should not be submitted to inclination, excessive vibrations, or blows (including 

during transportation and handling).

- The equipment must be installed in a level and stable place.

Before transporting the compressor, all air from the tank must be exhausted.