16
EQUIPMENT OPERATION
Cleaning methods
3
Advanced cleaning
Appropriate places: Automotive repair and hardware
manufacturers stores.
1. Place the objects directly in the cleaning tank.
Do not place objects over each other, to avoid friction
during cleaning.
2. Add water to a level between MIN and MAX above
the objects.
3. Press TC to turn the heater on
, it will flash.
To cancel the heating, press TC again when the water
temperature reaches 40ºC after about 20 minutes.
5. Press the SET button to set the clock to 10 minutes.
Press the On/Off button once to start cleaning. The fat
will be dissipated and will appear to be something as a
black smoke on the water.
6. Replace the water and wash the objects for an
additional 3 minutes to remove the debris.
4
Special cleaning
Appropriate places: Manufacturers of products made
of copper, silver or bronze.
1. Place the objects in the basket and then in the tank;
add water to a level between MIN and MAX above the
objects.
2. Press TC to turn on the heater
, it will flash. The
water temperature will reach 50ºC after 30 minutes.
(
it turns off after the set temperature is reached.)
3. Press the SET button to set the clock to 15 minutes.
4. Press the Function button to select the degassing
function. It will light up
.
Press the On/Off button to start the degassing.
After 90 seconds, the device will automatically switch
to normal cleaning mode.
5. When cleaning is complete, remove the basket and
objects. If there are many objects and some debris
remaining, add 5 minutes and repeat the cleaning.
6. Replace the water and wash the objects for more 3
minutes to remove the remaining chemical waste.
During cleaning the debris separate from the objects as "smoke”. The water becomes blurred.
This method will remove the rust and will cause objects to appear as new.