52
6. assemble the airbox with the sealings
7. reassemble the pivot of the air slider through the opening of the airbox
8. put the shortest end and the pivot of the air slider in the end of the air slider lever and put the cotter
pin back.
9. the air slider lever can be mounted onto the back
10. shake the air slider lever from left to right by means of control
11. when this is ok you can reassemble the back protection plate on the back of the stove
6. Installation of the stove
All local regulations, including those referring to national and European standerds need to be complied
when installing the appliance.
Only an appliance that is connected by a recognised installer guarantees compliance with the guidelines
regarding architecture and fire prevention. This is certainly necessary for correct and safe operation of the
stove.
The chimney plays a very important role in the connection of the stove. The qualified chimney-sweep must
therefore certainly be consulted about the connection, so that the applicable regional building regulations
are complied with.
Take the following into consideration:
•
The appliance can only be used when the door of the stove is closed. The doors of the stove must also
be closed when the appliance is not in use.
•
There must be an adequate supply of fresh air during operation of the appliance.
Fire protection measures with regard to flammable or heat-sensitive floor coverings:
•
The floor below the stove must be covered by a fireproof, non -flammable surface (e.g. cast-iron plate,
marble, tiles, etc.).
•
No flammable or heat-sensitive objects may be stored below the appliance (e.g. supply of firewood).
Safety distances from flammable or heat-sensitive objects:
3
2
5
4
6
Summary of Contents for ePure
Page 15: ...15 ...
Page 30: ...30 13 Pièces de rechange Vous pouvez obtenir des pièces de rechange auprès de votre revendeur ...
Page 45: ...45 ...
Page 60: ...60 ...
