17
6
I
NSTRUCTIONS FOR USE
Location of controls
A
–
control knob 1 and piezo ignition knob 2
B
–
the universal fitting of figure 4 or the BY-PASS sliding controller
C
–
placement of the thermostatic
6.1
Putting into operation
- Open the gas supply valve;
- Turn knob 1 to the ignition position * and push it in as far as it will go
- Press the piezoelectric ignition button 2. Do this repeatedly until the flame is lit and then keep knob 1
pressed for about 10 seconds.
- Release knob 1. When the flame has extinguished, repeat the above procedure, but wait 1 to 2 minutes
so that the gas in the fireplace can be sufficiently ventilated.
As soon as the ignition has succeeded sufficiently, set the desired room temperature with knob 1, e.g.
at position 4. Now, the main burner can be switched on if the room temperature measured by the
thermostat is lower than requested. Otherwise, the main burner will not start because the room
temperature is the same as the one set using the control knob. The numbers on the knob do not
correspond to a preset temperature, they are purely indicative. Therefore, it is important to keep an
eye on the room temperature and adjust the control knob so that the desired temperature is reached.
At night, you can move the control knob to e.g. position 1 to obtain a lower
temperature. If you wish to turn off the main burner and burn only the
ignition burner, turn the control knob to the * symbol.
See the "troubleshooting" section in case of problems with the ignition.
