9
XL-TG10153BM-en-US Rev A · 2013-06-27 · Amendments and Errors Reserved · © SAF-HOLLAND, Inc., SAF-HOLLAND, HOLLAND, SAF,
and logos are trademarks of SAF-HOLLAND S.A., SAF-HOLLAND GmbH, and SAF-HOLLAND, Inc.
Frame Preparation
Figure 8
Figure 7
5. Frame Preparation
Standard Mount
Failure to properly engage the vehicle
parking brake prior to installing the
liftgate may allow vehicle movement
which, if not avoided, could result in
death or serious injury.
NOTE:
Prior to installation verify the vehicle rear doorsill
will support required loads.
1. Remove bumper, step, or any protrusions that would
prevent the deck extension from being mounted flush
against the rear doorsill.
2. Follow the frame cutout requirements for your preferred
installation
(Figures 7 or 8)
.
NOTE:
Standard Mount: Additional frame modifications
may be necessary, depending on the application
(Figures 7 or 8)
.
STANDARD MOUNT
TRUCK INSTALL
POST
12" (304 mm)
14" (355 mm)
(FOR 61" [1549 mm]
PLATFORMS)
12" (304 mm)
14" (355 mm)
(FOR 61" [1549 mm]
PLATFORMS)
5.38"
(136 mm)
21" (533 mm)
(FOR 48" and 52"
[1219 and 1320 mm]
PLATFORMS)
26" (660 mm)
(FOR 61" [1549 mm]
PLATFORMS)
21" (533 mm)
(FOR 48" and 52"
[1219 and 1320 mm]
PLATFORMS)
26" (660 mm)
(FOR 61" [1549 mm]
PLATFORMS)
STANDARD MOUNT
TRAILER INSTALL
POST
8" (203 mm)
5.38"
(136 mm)
8" (203 mm)
