Danger!
• The fifth wheel kingpin must be checked for deformation
and tight fastening!
• Once the wear limits have been reached the respective
parts must be replaced immediately by an authorised
specialist workshop and by personnel with the appropriate
training.
The fifth wheel lock and the fifth wheel kingpin are subject to a certain
wear during operation.
If the limit values below are not reached, the pin must be replaced by an
original SAF-HOLLAND spare part.
For wear check on the fifth wheel kingpin, the limit gauges
1)
are
recommended.
Fifth wheel kingpin
1 Inspect the wear at the circumference
of the fifth wheel kingpin using the
two zones of the limit gauges by
SAF-HOLLAND.Fig. 10
2 The limit gauge must not slide over
the fifth wheel kingpin with its jaw. If
the limit gauge slides over the fifth
wheel kingpin, it must be replaced
immediately Page 21.
3 The height of the fifth wheel kingpin
in –Zone A–,Fig. 11 for 2”, must be
between min. 82.5 mm and max. 84
mm and for 3.5” between min. 72 mm and max. 74 mm as of the
lower edge of the trailer. If the dimensions do not match, the fifth
wheel kingpin must be replaced immediately Page 21.
KP-0005
Fig. 10
· Limit gauge wear check
1)
SAF-HOLLAND order number 659 920 032 for 2” and 659 920 033 for 3.5”
7 Inspection
27
XL-KP11695BM-en-DE Rev. A · 02.2015 · Errors and changes excluded · © SAF–HOLLAND
en
Summary of Contents for 50S15
Page 31: ......
