The CFIP Lumina Series Full Outdoor Unit Technical Description and Configuration Guide
•
Rev. 1.3
•
© SAF Tehnika JSC 2010
36
4 Detailed Configuration in Web Graphic User Interface
Configuration section in Web interface allows customizing your system to suit your
specific needs.
4.1 Main Configuration
The main configuration window provides the configuration of most vital system
parameters, including the ones in configuration wizard as well as some other important
parameters. Below is a short explanation of provided customization fields.
4.1.1 Radio Configuration
1.
Radio data status
– shows if management CPU was able to read data from
radio;
2.
Radio side
– shows if radio side you are currently viewing is low or high
(command line
–
radio side
);
3.
Tx power
– allows you to define transmitter power. If the RSL is too high
(much higher than normal -50dBm), you might want to lower transmitter
power. Too high Rx level (>20 dBm) may even result in synchronization loss.
The minimum and maximal values you can choose are dependent on
modulation type and CFIP model. Maximal and minimal Tx power values are
shown in the brackets. (command line -
radio txpower
[<power dBm>]
);
4.
Tx frequency (22014000 .. 22582000 KHz)
– allows you to enter preferable
transmitter frequency, hence defining utilized channel (command line -
radio
txfreq
[<freq KHz>]
);
5.
Rx frequency
– shows the current receiver utilized frequency (command line -
radio freq
);
6.
Duplex shift
– shows the duplex shift between the transmitter frequency and
receiver frequency (command line -
radio duplexshift
);
7.
Tx mute
– allows turning transmitter power off. It may be effective when
diagnosing on interference existence
– when transmitter power of one side is
off, you should not experience significant RSL on the other side (command
line -
radio txmute
[on|off]
);
8.
Pressing “
Execute configuration
” applies changes made to the corresponding
section only for the local side CFIP Lumina
. If “Rollback on” is selected,
(!)
In the table below please see interdependence between antenna used and allowed
C
FIP Lumina 24GHz Tx output power range (EIRP ≤ 20 dBm).
Antenna size/gain
30cm / 35.0dBi
60cm / 40.3dBi
Tx power
-
20…-15 dBm
-20 dBm