The CFIP Lumina Series Full Outdoor Unit Technical Description and Configuration Guide
•
Rev. 1.3
•
© SAF Tehnika JSC 2010
47
4.3 IP Configuration Window
The IP configuration window provides configuration of the Ethernet management port
addressing, IP services and routes. Settings listed here are essential for building a network or
other specific traffic purposes.
Explanation of customization fields:
4.3.1 Ethernet management port IP configuration
1.
IP Address
– allows specifying IP address of CFIP Lumina you are currently
logged in. Default IP address is 192.168.205.10 or 192.168.205.11
–
depending on which side the specific CFIP Lumina is
– low side has
192.168.205.10 IP address and high side
– 192.168.205.11 (command line –
net ip addr
<addr>
);
2.
IP Mask
–
allows specifying IP mask of CFIP Lumina you are currently
logged in.
Default IP mask is 255.255.255.0, and it should not be changed
unless you are owning network with huge amount of hops (command line
–
net ip mask
<mask>
);
3. IP Default gateway
–
allows specifying gateway of CFIP Lumina you are
currently logged in. Default gateway is 255.255.255.255 which means that
there is no gateway specified (command line
–
net ip gw
<gw>
);
4.
Ethernet MAC address
–
shows the MAC address of CFIP Lumina you are
currently logged in (command line
–
net mac
);
5.
Remote IP Address
–
shows IP address of remote (far-end) CFIP Lumina to
ensure communication between link sides (command line
–
net ip remaddr
<remaddr>
);
6. Pressi
ng “Execute configuration” applies changes made to the corresponding
section only for the local side CFIP Lumina
. If “Rollback on” is selected,
configuration will be reverted in case of erroneous configuration changes
applied.
4.3.2 IP Services
1.
FTP service
–
starts FTP service for file access and software update of your
CFIP Lumina. By default FTP service is not running (command line
–
net
start ftp
);
(!)
Note that Advanced Ethernet information page resets all counters and gathers Ethernet
information. Please wait until information is gathered and displayed.
.
(!)
Note that CFIP Lumina IP addresses need to be in the same subnet.
