The CFIP Lumina Series Full Outdoor Unit Technical Description and Configuration Guide
•
Rev. 1.3
•
© SAF Tehnika JSC 2010
91
7 Software Update
To simplify the software update process, SAF Tehnika provides special update package,
as a new version is available. This update pack is available as archive (e.g. zip), which
includes firmware file (with *.elf.ezip extension), boot configuration file (with *.ini extension)
and other files needed for update process. To receive update pack, please contact your SAF
Tehnika distributor.
The main method for software upgrade is Web GUI software upgrade, which automates
the whole software upgrade process. To perform software upgrade from Web GUI, please go
to “Configuration
System configuration” and in “Upgrade software” section press
“Browse…” button and locate software upgrade file (e.g. cfipl000.elf.ezip) on your hard disc
(see Chapter 4.2.4 for detailed explanation of Web GUI upgrade).
Besides there are other various ways how the user can update the CFIP management
software by uploading the appropriate firmware file to the CFIP Lumina flash disk and further
editing boot configuration file if necessary. The file upload can be performed:
–
via Ethernet management port using update package,
–
via Ethernet management port using FTP,
–
via Ethernet management port using TFTP, or
via RS232 serial port using Xmodem protocol.
Following chapters
describe other methods how to update software.
7.1 Update Software with Update Pack
To update CFIP software using the update pack, proceed as follows:
–
uncompress the package;
–
change the CFIP IP address to 192.168.205.10,
or
edit „send.205.xx‟ files by replacing
“192.168.205.10” with actual CFIP IP address;
–
arp
–d
ip_addr
[
if_addr
] deletes the host specified by ip_addr. If another host with a
duplicate IP address exists on the network, the ARP cache may have had the MAC
address for the other computer placed in it.
arp
–d
is used to delete an entry that
may be incorrect. By default no host is specified.
–
rem
ttftp.exe 192.168.205.10 put help.txt
prefix ignores command execution