User Guide
Restrict Management VLAN to interfaces - select interfaces on which management
access will be restricted.
2.2 Radio
Use the Configuration | Radio menu to set up radio settings for the point-to-point link:
Operating mode - specify the operating mode of the local device to create point-to-
point link [Master/Slave]. The device mode depends on the network topology.
Master - in this mode local device is the controlling point-to-point link unit.
Slave - in this mode local device connects to the Master unit.
Link ID - specify known network name of the remote device to establish a point-to-point
link.
2.1.1 Instant
Changes
The goal of the instant changes is that after settings has been changed, there is no need
to reboot the device.
Country - choose from drop-down list the country in which the device will operate.
According to the country chosen the regulatory domain settings change. You are not
allowed to select radio channels and RF output power values other the permitted values
for your country and regulatory domain.
Frequency - specify frequency at which the point-to-point link will be operating.
(!) The available Frequencies list varies depending on the selected Country and
Channel width.
Channel width - choose the channel width in MHz [5/10/20/40].
“CFOL Series”, User Guide
© SAF Tehnika A/S 2009
13
