Insert four more Cams into the
large
holes of the Vertical
Divider. Screw the I Screw Posts into each
small hole
that has a
plastic insert
(do not over-tighten).
Tap J Wood Dowels into each hole located next to a
Screw Post on the Side Panels and the Fixed Shelf.
5390-37: 2 of 4; Rev. 3: 11/04
Safco Products Company, New Hope, MN 55428
Work on a smooth, clean surface. Locate the A Back
Panel and position it with the large holes up. Lay the B Left
Panel and the C Right Panel on the left and right sides of
the Back Panels with the holes facing up as shown.
Arrange the D Fixed Shelf and two E Rails above the Back
Panel withthe holes up. Place the G Vertical Divider below
the Back Panels with the four large holes up.
Insert four H Cams into the large holes at the corners of
the Back Panel, the Fixed Shelf and both Rails, with the
arrows pointing toward the nearest hole in the edge.
1
Locate the F Base Panel. Position the Panel with
the four large holes up. Attach the K Casters to the
two corners along one long edge using four M
Small Screws per Caster. Attach the L Casters with
Brakes to the two corners along one long edge
using four M Small Screws per Caster.
2
B
C
I
G
Turn the base panel upright onto the Casters. Insert
two I Screw Posts into the two small holes that
have a plastic insert (do not over-tighten).
Tap two J Wood Dowels into the holes located
next to the Screw Posts as shown.
3
L
K
F
I
M
A
H
H
I
D
J
E
J
